Having a working windshield washer is one of the things you shouldn’t do without. First of all, we think of driving ease, but it is necessary to know that this also means your protection at the wheel because of the importance of visibility when driving your Ford F 150 .
In this article we will make clear step by step how to recognize the fault and solve it in order to have an effective windscreen washer.
Identify the failure of the windscreen washer of your Ford F 150 :
First thing to look out for before handling, have you filled your cleaning fluid? If so, let’s see what causes prevent your equipment from operating properly.Wipers-no-longer-work-ford-f-150 

Causes for wipers that no longer work on your Ford F 150 

Very often, your equipment is obstructed by accumulated dirt or limescale. This is the main factor that will prevent your equipment from working. To remedy this, try to unclog your sprinklers. These holes allow the product to be propelled onto your Ford F 150 ‘s windshield. It is very likely that they are obstructed, by accumulation of limestone, or various types of dirt. To do this, you can start by trying to blow, yourself or with some efficient equipment, such as a bicycle pump or ideally the tire inflator at your gas station.

How to fix wipers that no longer work

If nothing can be done, try to get yourself a thin, durable thing, such as a paper clip, that will enable you to gain access to the interior without losing a piece. We recommend that you also use a mixture of vinegar and hot water to optimize your results.
Repeat the test, if it still doesn’t work, maybe it’s obstructed at a deeper place, at the connection pipe. This is the link between the pump and the nozzle in your Ford F 150 .
To reach it, you will have to open your cover:
You should find the two hoses specific to each nozzle. Try to tidy them and of course make sure they are properly connected. Use the same cleaning procedures described above. When they are cleaned, you should be capable to circulate water through them without any problems. Then plug them back in properly, and repeat the test on your Ford F 150 . If it still doesn’t work, you now understand that it doesn’t come from the sprinklers or the pipes.
After that, you should then check the pump. It is the one who starts the product launch.
You will find it near the cleaning fluid reservoir under your Ford F 150 ‘s hood.
First test to find out if it works, when you turn on the washer, you are expected to hear a noise when the pump is activated. In the absence of noise, this denotes that it does not work. It will then have to be replaced.
It is a very basic thing to do . First, take out the two screws that enable it to be fixed on your Ford F 150 .
Then, you must find two power wires. They are mainly black and red. They have to be disconnected, but be careful, they must be reconnected in the right direction afterwards, or you could create a short circuit on your Ford F 150 . A little tip to remember: the red wire symbolizes the + terminal. For example, place a piece of red tape on it to make sure you can find it. Do the same with the black tape on the bollard – . Thanks to this, you will be able to reconnect the wire of the right color without any problem later on.
Once completed, you can remove the old pump and place the new pump on your Ford F 150 . Reconnect the cables correctly using the tip, then just screw the two retaining screws back on.
Now run a test again.
Everything should be back to normal by now.

In the event that you have any additional questions about the Ford F 150 , do not hesitate to consult our Ford F 150  category.