Having a working windshield washer is one of the things you shouldn’t do without. First of all, we think of driving comfort, but it is important to know that this also implies your safety at the wheel because of the importance of field of vision when driving your Ford Fusion.
In this article we will make clear step by step how to recognize the fault and solve it in order to have an effective windscreen washer.
Identify the failure of the windscreen washer of your Ford Fusion:
First thing to check for before handling, have you filled your cleaning fluid? If so, let’s see what causes prevent your equipment from working properly.Wipers-no-longer-work-ford-fusion

Causes for wipers that no longer work on your Ford Fusion

Very often, your equipment is blocked by accumulated dirt or limescale. This is the main factor that will prevent your equipment from working. To stop this, try to unclog your sprinklers. These holes make it possible for the product to be propelled onto your Ford Fusion’s windshield. It is very likely that they are clogged, by accumulation of limestone, or various types of dirt. To do this, you can get started with by trying to blow, yourself or with some efficient equipment, such as a bicycle pump or preferably the tire inflator at your gas station.

How to fix wipers that no longer work

If nothing can be done, try to get yourself a thin, durable object, such as a paper clip, that will allow you to access the interior without losing a piece. We recommend that you also employ a mixture of vinegar and hot water to optimize your results.
Repeat the test, if it still doesn’t work, maybe it’s blocked at a deeper place, at the connection pipe. This is the link between the pump and the nozzle in your Ford Fusion.
To reach it, you will have to open your cover:
You should identify the two hoses specific to each nozzle. Try to tidy them and of course make sure they are properly connected. Use the same cleaning procedures explained above. When they are cleaned, you should be capable to circulate water through them without any problems. Then plug them back in correctly, and repeat the test on your Ford Fusion. If it still doesn’t work, you now understand that it doesn’t come from the sprinklers or the pipes.
After that, you should then check the pump. It is the one who sets out the product launch.
You will find it near the cleaning fluid reservoir under your Ford Fusion’s hood.
First test to see if it works, when you turn on the washer, you are expected to hear a noise when the pump is activated. In the absence of noise, this denotes that it does not work. It will then have to be replaced.
It is a very simple thing to do . First, take out the two screws that allow it to be fixed on your Ford Fusion.
Then, you must identify two power wires. They are mainly black and red. They must be disconnected, but be careful, they must be reconnected in the right direction afterwards, or you would create a short circuit on your Ford Fusion. A little tip to bear in mind: the red wire is a symbol of the + terminal. For example, put a piece of red tape on it to be certain you can find it. Do the same with the black tape on the bollard – . Thanks to this, you will be able to reconnect the wire of the right color without any difficulty later on.
Once completed, you can dispose of the old pump and insert the new pump on your Ford Fusion. Reconnect the cables in the right way using the tip, then just screw the two retaining screws back on.
Now run a test again.
Everything should be back to normal by now.

If you have any additional questions about the Ford Fusion, do not hesitate to consult our Ford Fusion category.