Having a working windshield washer is one of the things you shouldn’t do without. First of all, we think of driving ease, but it is important to know that this also signifies your safety at the wheel because of the importance of visibility when driving your Honda Civic.
In this article we will explain step by step how to identify the fault and solve it in order to have an effective windscreen washer.
Identify the failure of the windscreen washer of your Honda Civic:
First thing to check for before handling, have you filled your cleaning fluid? If so, let’s see what causes prevent your equipment from functioning properly.Wipers-no-longer-work-honda-civic

Causes for wipers that no longer work on your Honda Civic

Very often, your equipment is blocked by accumulated dirt or limescale. This is the main factor that will stop your equipment from working. To remedy this, try to unclog your sprinklers. These holes make it possible for the solution to be propelled onto your Honda Civic’s windshield. It is very likely that they are clogged, by accumulation of limestone, or various types of dirt. To do this, you can start by trying to blow, yourself or with some efficient equipment, such as a bicycle pump or preferably the tire inflator at your gas station.

How to fix wipers that no longer work

If nothing can be done, try to get yourself a thin, durable thing, such as a paper clip, that will allow you to gain access to the interior without losing a piece. We advise that you also employ a mixture of vinegar and hot water to optimize your results.
Repeat the test, if it still doesn’t work, maybe it’s blocked at a deeper place, at the connection pipe. This is the link between the pump and the nozzle in your Honda Civic.
To reach it, you will have to open your cover:
You should find the two hoses specific to each nozzle. Try to clean them and obviously make sure they are properly connected. Use the same cleaning procedures explained above. When they are cleaned, you should be able to circulate water through them without any problems. Then plug them back in correctly, and repeat the test on your Honda Civic. If it still doesn’t work, you now understand that it doesn’t come from the sprinklers or the pipes.
After that, you should consequently check the pump. It is the one who sets out the product launch.
You will find it near the cleaning fluid reservoir under your Honda Civic’s hood.
First test to ascertain if it works, when you turn on the washer, you are expected to hear a noise when the pump is activated. In the absence of noise, this suggests that that it does not work. It will then have to be replaced.
It is a very basic thing to do . First, remove the two screws that allow it to be fixed on your Honda Civic.
Then, you must find two power wires. They are mainly black and red. They need to be disconnected, but be aware, they must be reconnected in the right direction soon after, or you would create a short circuit on your Honda Civic. A little tip to keep in mind: the red wire symbolizes the + terminal. For example, place a piece of red tape on it to make sure you can find it. Do the same with the black tape on the bollard – . Thanks to this, you should be able to reconnect the wire of the right color without any difficulty later on.
Once completed, you can remove the old pump and place the new pump on your Honda Civic. Reconnect the cables in the right way using the tip, then just screw the two retaining screws back on.
Now run a test again.
Everything should be back to normal by now.

If you want more guides on the Honda Civic, go to our Honda Civic category.